Rack Accessories: Tool-Less 19-Inch Fixed Switch Unit
Side Blanking Panels
These panels form part of our increasing range of modular
thermal management components developed to optimise
cabinet cooling effectiveness whilst at the same time also
increasing power efficiency within the data room.
By using a range of modular components including our
vertical brush strips, quick fit 19-inch blanking and these
fixed side blanking plates users can quickly and easily
configure an Access Cabinet to manage active
equipment having air flow cooling requirements other
than conventional front to back aspiration.
This type of scenario is
often associated with the
deployment of network
switches including the
Cisco 6500 series where
the switch section breathes
left to right across the unit.
By filling up the aperture
between the front and rear
mounting angles and only
leaving the air intake /
exhaust outlet areas open the flow of the cold air can be
optimised and directed to the critical areas.
Incorporating the same tool-less ¼-turn fixings as we use in
the front 19-inch blanking panels these panels can be easily
and quickly fitted to the side mount facility found on all Access
Cabinet configurations with the exception of our “3 into 2”
cabinet range. Essential for blanking off any open voids
between the front and rear mounting angles these panels are
available in 1U, 2U and 5U increments.
NOTE
Front quick release 19-inch and
side blanking panels shown
finished in light grey for clarity.
Actual panels are finished in
Black RAL9005.
|
|
Sizes |
1U |
2U |
5U |
Material |
Panel - Mild steel 1.2mm thick (18swg)
Fixings – Black Polycarbonate |
Finish |
Painted RAL9005 Black |
Fixing Type |
Tool-less ¼ Turn Fasteners |
Simple Operation
Assembly
- Locate the fixing into the panel
- Tap the actuating pin into the receptacle as
shown in “B”. When the slot in the head of the
actuating pin is horizontal the fixing is latched.
Panel Mounting
- Rotate actuating pins so that the slot in the head is vertical. Locate the
appropriate panel in the relevant empty unit position.
- Turn each of the ¼ turn fixings through 90 degrees so slots in actuating pins
are horizontal securely latching the panel in position.
Panel Reposition
- Turn each of the ¼ turn fixings through 90 degrees to unlatch the panel and
reposition as necessary.
| |
Order Code |
Description |
Shipping
Weight |
 |
SWSBP1UQFB |
11U Quick Fit Switch Side Blanking Panel.
270.0mm Wide x 44.0mm High
Finished RAL9005 Black |
0.13kg |
 |
SWSBP2UQFB |
2U Quick Fit Switch Side Blanking Panel.
270.0mm Wide x 89.0mm High
Finished RAL9005 Black |
0.25kg |
 |
SWSBP5UQFB |
5U Quick Fit Switch Side Blanking Panel.
270.0mm Wide x 222.0mm High
Finished RAL9005 Black |
0.60kg |
Note – 19-inch mounting angles need to be set at 415mm centres measured from face to face of each angle front to rear.